Providing Professional
Plastic Injection Moulds To The World
-
Call Us Now +86-576-81106826
-
Send Mail To info@solidcomould.com
Providing Professional
Plastic Injection Moulds To The World
The rotational speed of the screw significantly affects the degree of stability of the injection moulding process and the amount of heat acting on the plastic. The faster the screw...
In order to prevent plastic from flowing out of the nozzle, a decompression (rewinding) device or a special shooting nozzle is also installed. If you use a stop-flow production and...
Some plastics need to be vented in the shooting tank during injection moulding to allow the gas to escape. In most cases these gases are only air, but they may be melted moisture o...
The melt usually flows from the nozzle into the nozzle, but with some moulds, the nozzle is part of the mould because it extends to the bottom of the mould. There are two main type...
1. The difference in the particle size of the raw materials is large, making it difficult to uniformly plasticize and the gloss is poor. For this, the raw materials should be sieve...
1. If the injection speed is too small, the surface of the plastic part is not dense, and the gloss is poor. For this, the injection speed can be appropriately increased. 2. For th...
Please leave your Email or phone nomber, so we can contact you as soon as possible.
Share
